Home / Industries / Automotive
Automotive wire harnesses and cable assemblies
Prototype and pilot-run harnesses for vehicles, autonomy retrofits, off-highway equipment and test benches. Low-voltage systems only.
Built to IPC/WHMA-A-620 · 48 hours Bay Area delivery
Connector and cable families
What we terminate for automotive.
Families, not single part numbers. If yours isn't here, send the part number and we'll quote it.
Sealed rectangular
Deutsch DT
Deutsch DTM
Deutsch DTP
Deutsch DTHD
Deutsch HD10 / HD30 circular
TE AMP Superseal 1.5
Molex MX150
Molex MX123
Aptiv Metri-Pack 150 / 280 / 480 / 630
Aptiv GT 150 / 280
Aptiv Weather Pack
Sumitomo TS / HM
Unsealed and in-cabin
TE MCP and MQS
TE Junior Power Timer
Molex Mini50
Aptiv Micro-Pack 100W
Data and RF
FAKRA
HSD
H-MTD
Automotive Ethernet 100/1000BASE-T1 (MATEnet, H-MTD)
OBD-II J1962
CAN / LIN twisted pair
Power
Ring, fork and spade terminals
Battery lugs to 4/0 AWG
Anderson SB
Blade fuse holders and relay sockets
Amphenol SurLok Plus
Wire and protection
TXL / GXL / SXL
FLRY-A / FLRY-B
Convoluted loom
Braided sleeving
Adhesive-lined heat shrink
Harness tape (cloth and PVC)
Assemblies we build
- Sealed sensor and actuator harnesses
- Autonomy and compute retrofit harnesses
- CAN / LIN / automotive Ethernet backbones
- Camera and radar coax runs
- Battery, fuse and relay box wiring
- Bench, HIL and test-fixture harnesses
Tests on these assemblies
- Point-to-point continuity and shorts
- Crimp pull force per terminal lot
- Insulation resistance
- Seal and terminal-retention check
- Dielectric withstand on request
Other industries: Automation & Robotics · Consumer Electronics · Data Center · Capabilities and testing
FREE · NO STRINGS
Want a sample? We'll deliver one for free.
Tell us what you're building. We'll build a sample assembly to your spec and bring it to your door anywhere in the Bay Area, so you can check our work on your own bench.
Get my free sampleTakes 30 seconds. No account, no commitment.