USB Type-C to Type-C cable, USB 2.0, 3 A

Consumer Electronics

1.0 m USB Type-C to Type-C cable assembly, USB 2.0 data, 3 A rated. 28 AWG data pair, 24 AWG VBUS and GND, foil and braid shield.

CustomerSample customer

Customer PO—

DrawingBAH-3008 rev A

LotSAMPLE

Quantity tested25 of 25

WorkmanshipIPC/WHMA-A-620 Class 2

Test date2026-10-25

Serials001–025

Results

Test	Method	Requirement	Measured	Passed	Status
Point-to-point continuity	All populated pins, P1 to P2	Per pinout, no opens	Pass	25 / 25	PASS
Shorts and isolation	All pin pairs, 100 VDC	≥ 100 MΩ	> 1 GΩ	25 / 25	PASS
VBUS + GND loop resistance	4-wire, end to end	≤ 0.25 Ω (per drawing)	0.138–0.151 Ω	25 / 25	PASS
Differential impedance, D+/D-	TDR, 200 ps rise time	90 Ω ± 15%	86.2–92.7 Ω	5 / 5 sampled	PASS
Shield continuity	Shell to shell	≤ 0.5 Ω	0.09–0.14 Ω	25 / 25	PASS
CC line	CC to CC continuity	Per pinout	Pass	25 / 25	PASS
Visual inspection	Strain relief, solder joints, marking	IPC/WHMA-A-620 Class 2	Accept	25 / 25	PASS

LOT ACCEPTEDAll 25 assemblies met every requirement on drawing BAH-3008 rev A.

Test equipment

Instrument	Used for	Calibration
Cable tester	Continuity, shorts, miswire, insulation resistance	Current, record on request
4-wire micro-ohmmeter	Contact and conductor resistance	Current, record on request
TDR	Differential impedance	Current, record on request
Stereo microscope	10–40× visual inspection	Current, record on request

Tested by

Reviewed by

Date

Electrical verification to the customer drawing only. This is not USB-IF compliance testing.

This is a sample report with illustrative values. Your report lists your drawing, lot, serial numbers, the requirements on your drawing, and the measured results for every assembly. Questions: support@bayareaharness.com